Cables & Protection

A ready-made pair of weatherproof PV connectors with short 10 AWG leads, handy for extending panel cables or building a branch harness. Plug together hand-tight and keep the contacts clean and dry.

Protection

IP67

Single-conductor PV wire with a sunlight-resistant jacket for the run from the panels to the combiner box or controller. Cut it to length and finish it with crimped MC4-type contacts.

Jacket

UV-resistant, cross-linked

A ratcheting crimper that releases only after a full crimp cycle, so every contact is pressed the same way. Use it for MC4-type pins and sockets on 12 to 10 AWG PV wire; it is not meant for large battery lugs.

Mounts directly on the battery post so every branch circuit gets its own fuse right at the source. A neat way to protect an inverter feed, a winch lead and accessory lines on a vehicle or boat bank.

Heavy 4 AWG jumper cables with insulated handles for jump-starting a car or moving charge between a house bank and a starting battery. Good to keep next to a battery bank for emergencies.

A commercial-grade 20 A receptacle with a T-slot that takes both 15 A and 20 A plugs. A common choice for the AC outlet on an inverter panel or a van or workshop sub-panel; to be wired by a qualified electrician.

A weatherproof enclosure where panel strings meet before one cable continues to the inverter or controller. Cable glands keep the wiring tidy and sealed; fuse holders and a surge protector are fitted to suit your design.